Removing and Installing Parts 149
6
Carefully remove the I/O panel from the computer.
Installing the I/O Panel
1
Place the I/O panel into the slot.
NOTICE: Take care not to damage the cable connectors and the cable routing clips
when sliding the I/O panel into the computer.
2
Align and slide the I/O panel clamp into the I/O panel clamp slot.
3
Replace and tighten the screw that secures the I/O panel.
4
Reconnect the cables to the system board.
5
Replace the bezel (see "Replacing the Bezel" on page 122).
6
Replace the computer cover (see "Replacing the Computer Cover" on page 160).
7
Connect your computer and devices to an electrical outlet, and turn them on.
8
Verify that the computer works correctly by running the Dell Diagnostics
(see "Dell Diagnostics" on page 84).
1 I/O panel clamp 2 I/O panel 3 screw
4 cables 5 I/O panel clamp slot
1
2
3
4
5
book.book Page 149 Monday, December 10, 2007 3:12 PM
To Next Page
Loading...
