160 Removing and Installing Parts
5
Replace the memory modules into the memory sockets at the same
locations from which you removed them (see "Installing Memory" on
page 111).
6
Replace any add-in cards on the system board.
7
Replace the computer cover (see "Replacing the Computer Cover" on
page 160).
8
Connect your computer and devices to an electrical outlet, and turn them on.
9
Verify that the computer works correctly by running the Dell Diagnostics
(see "Dell Diagnostics" on page 84).
Replacing the Computer Cover
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
CAUTION: Do not operate your equipment with any cover(s) (including computer
covers, bezels, filler brackets, front-panel inserts, etc.) removed.
1
Ensure that all cables are connected, and fold cables out of the way.
2
Ensure that no tools or extra parts are left inside the computer.
3
Align the tabs at the bottom of the computer cover with the slots located
along the edge of the computer.
4
Press the computer cover down and slide it towards the front of the computer
until you feel a click or feel the computer cover securely installed.
5
Ensure that the cover is seated correctly.
book.book Page 160 Monday, December 10, 2007 3:12 PM
To Next Page
Loading...
