Removing and Installing Parts 159
System Board Screws
Place the system board assembly that you just removed next to the
replacement system board to compare and ensure they are identical.
Installing the System Board
1
Gently align the board into the chassis and slide it toward the back of the
computer.
2
Using the eight screws, secure the system board to the chassis.
3
Replace the cables that you removed from the system board.
4
Replace the processor and the heat sink assembly (see "Installing the
Processor" on page 154).
NOTICE: Ensure that the heat sink assembly is correctly seated and secure.
1 screws (8) 2 system board
1
2
book.book Page 159 Monday, December 10, 2007 3:12 PM
To Next Page
Loading...
