152 Removing and Installing Parts
3
Connect the processor fan/heat sink assembly cable to the CPU_FAN
system board connector (see "System Board Components" on page 104).
4
Replace the computer cover (see "Replacing the Computer Cover" on
page 160).
5
Connect your computer and devices to an electrical outlet, and turn them on.
Processor
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
Removing the Processor
1
Follow the procedures in "Before You Begin" on page 99.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 101).
CAUTION: Despite having a plastic shield, the heat sink assembly may be very
hot during normal operation. Be sure that it has had sufficient time to cool before
you touch it.
3
Remove the processor fan/heat sink assembly from the computer (see
"Removing the Processor Fan/Heat Sink Assembly" on page 150).
NOTICE: Unless a new heatsink is required for the new processor, reuse the
original heat sink assembly when you replace the processor.
book.book Page 152 Monday, December 10, 2007 3:12 PM
To Next Page
Loading...
