Memory module
Removing the memory module
Prerequisites
NOTE: The primary memory module is integrated into the system board. This procedure is for removing the secondary
memory module.
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the location of the memory module and provides a visual representation of the removal procedure.
Steps
1. Lift the Mylar to reveal the memory module.
2. With the memory module visible, use your fingertips to spread apart the securing clips on the memory-module slot until the memory
module pops up.
3. Slide and remove the memory module from the memory-module slot.
Installing the memory module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the memory module and provides a visual representation of the installation procedure.
Removing and installing components
17
To Next Page
Loading...
