Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
2. Slide the solid-state drive into the solid-state slot on the system board.
3. Replace the screw (M2x3) that secures the solid-state drive to the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
4. If you have installed an Intel Optane memory, enable the Intel Optane memory. For more information about enabling the Intel Optane
memory, see
Enabling Intel Optane memory.
Wireless card
Removing the wireless card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the location of the wireless card and provides a visual representation of the removal procedure.
Removing and installing components
25
To Next Page
Loading...
