Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
NOTE:
If you do not hear the click, remove the memory module and reinstall it.
3. Cover the memory module with the Mylar.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Hard-drive assembly
Removing the hard-drive assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the location of the hard-drive assembly and provides a visual representation of the removal procedure.
18
Removing and installing components
To Next Page
Loading...
