6. Lift the power-button board off the palm-rest and keyboard assembly.
Installing the power-button board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of power button and provides a visual representation of the installation procedure.
Steps
1. Align and place the power-button board into the slot on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x2) and the two screws (M2x3) that secure the power-button board to the palm-rest and keyboard
assembly.
3. Adhere the adhesive tape above the power-button board.
4. Connect the power-button cable to the connector on the system board and close the latch.
5. Close the right display hinge and replace the three screws (M2.5x5) that secure the right display hinge to the palm-rest and keyboard
assembly.
54
Removing and installing components
To Next Page
Loading...
