Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of power-adapter port and provides a visual representation of the installation procedure.
Steps
1. Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
2. Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
3. Connect the power-adapter cable to the connector on the system board.
Next steps
1. Install the display assembly.
2. Install the battery.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Power button
52
Removing and installing components
To Next Page
Loading...
