Steps
1. Adhere the coin-cell battery to the palm-rest and keyboard assembly.
2. Route the coin-cell battery cable through the routing guides.
NOTE:
Depending on the configuration ordered, you may need to re-route the speaker cable through the same
guides and re-apply the tape which adheres the coin-cell battery cable to the palm-rest and keyboard assembly.
3. Connect the coin-cell battery cable to the system board.
4. Route the speaker cable through the routing guides on the system board.
5. Adhere the tape that secures the speaker cable to the system board.
6. Connect the speaker cable to the system board.
Next steps
1. Install the solid-state drive/Intel Optane memory.
2. Install the wireless card.
3. Install the battery.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
48
Removing and installing components
To Next Page
Loading...
