About this task
The following image indicates the location of the power button with fingerprint reader and provides a visual representation of the
installation procedure.
Steps
1. Align and place the power button with fingerprint reader into the slot on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x3) that secure the power button with fingerprint reader to the palm-rest and keyboard assembly.
3. Replace the two screws (M2x2) that secure the power button with fingerprint-reader bracket to the palm-rest and keyboard
assembly.
4. Connect the fingerprint-reader cable to the connector on the power-button board.
5. Connect the power-button cable to the connector on the system board.
6. Close the right-display hinge and replace the three screws (M2.5x5) to secure the right display hinge to the palm-rest and keyboard
assembly.
Next steps
1. Install the I/O board.
2. Install the fan.
3. Install the battery.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
Removing and installing components
57
To Next Page
Loading...
