Installing M.2 Solid State Drive (SSD)
1 Align the notch on the SSD card with the tab on the SSD card connector and slide the card into the slot.
2 Align the screw hole on the SSD card with the screw hole on the system board.
3 Replace the screw that secures the SSD card to the system board.
4 Install the:
a battery
b base cover
c microSD card
5 Follow the procedure in After working inside your computer.
Power switch board
Removing power switch board
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
c battery
3 To remove the power switch:
a Disconnect the power switch cable from the power switch board [1].
b Remove the M.2.0x3.0 screws that secure the power switch board on the computer [2].
c Lift the power switch board away from the computer [3].
18
Removing and installing components
To Next Page
Loading...
