Solid state drive
Removing the SSD card
1 Follow the procedure in Before working inside your computer.
2 Remove the :
a base cover
b battery
3 To remove the Solid State Drive (SSD) card:
a Peel the adhesive mylar shield that secures the SSD card [1].
NOTE: Need to be removed carefully in order to be reused on the replacement SSD.
b Remove the single (M2*3) screw that secures the SSD to the system [2].
c Slide and lift the SSD from the system [3].
Installing the SSD card
1 Insert the SSD card into the connector on the system.
2 Replace the single (M2*3) screw that secures the SSD card to the system.
3 Place the Mylar shield over the SSD.
4 Install the :
Removing and installing components
11
To Next Page
Loading...
