Installing the chassis frame
1 Place the chassis frame into the slot on the system.
2 Replace the 2 (M2x3) screws, 3 (M2x5) screws and the 2 (M2x2) screws to secure the chassis frame to the system.
3 Connect the keyboard cable and the keyboard backlight cable to the connector on the system.
NOTE
: There may be more than one cable to connect based on keyboard types. The keyboard cables need to go through
the chassis frame not under it.
4 Route the WLAN and WWAN (optional) cables through the routing channels.
5 Route and connect the speaker cable to the connector in the system board.
6 Install the:
a WWAN card (optional)
b WLAN card
c SSD frame
d SSD with holder
e SSD card
f hard drive assembly
g memory module
h battery
i base cover
7 Follow the procedure in After working inside your system.
Removing and installing components
27
To Next Page
Loading...
