b base cover
c battery
d memory module
e hard drive assembly
f SSD card
g SSD with holder
h SSD frame
i WLAN card
j WWAN card (optional)
k keyboard lattice
l keyboard
m heat sink assembly
n chassis frame
3 Disconnect the following cables from the system board:
a Touchpad cable [1]
b LED board cable [2]
c USH cable [3]
4 To release the system board:
a Flip over the system and remove the single M2*3 screw that secures the display cable bracket in place [1].
b Lift the metal display cable bracket from the system [2].
c Disconnect the display cable from the connectors on the system board [3].
d Disconnect the power connector port cable from the connector on the system board [4].
e Remove the 2 (M2*5) screws that secure the type-C USB bracket in place [5].
NOTE
: The metal bracket secures the DisplayPort over USB Type-C.
32 Removing and installing components
To Next Page
Loading...
