Installing power connector port
1 Align the power connector port along the grooves on the slot and push it down.
2 Place the metal bracket on the power connector port.
3 Replace the single (M2x3) screw to secure the power connector bracket to the power connector port.
4 Connect the power connector cable to the connector on the system board.
5 Install the :
a battery
b base cover
6 Follow the procedure in After working inside your computer.
Chassis frame
Removing the chassis frame
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
c memory module
d hard drive assembly
e SSD card
Removing and installing components
25
To Next Page
Loading...
