Installing the keyboard
1 Hold the keyboard and route the keyboard cable and the keyboard backlight cable through the palmrest in the system.
2 Align the keyboard with the screw holders on the system.
3 Replace the screws to secure the keyboard to the system.
4 Turn the system and connect the keyboard cable and the keyboard backlight cable to the connector in the system.
5 If you have not removed the battery, you must connect the battery cable to the system board.
6 Install the:
a keyboard lattice
b battery
c base cover
7 Follow the procedure in After working inside your computer.
Power connector port
Removing the power connector port
1 Follow the procedure in Before working inside your computer.
2 Remove the :
a base cover
b battery
3 To remove the power connector port:
a Disconnect the power connector cable from the connector on the system board [1].
b Remove the single M2x3 screw to release the power connector bracket that secures the power connector port to your system
[2].
c Remove the power connector bracket from the system [3].
d Pull the power connector port, and lift it away from the system [4].
24
Removing and installing components
To Next Page
Loading...
