1. Loosen the captive screw that secures the WLAN card bracket to the WLAN card.
2. Remove the WLAN card bracket off the WLAN card.
3. Disconnect the antenna cables from the WLAN card.
4. Remove the WLAN card at an angle from the WLAN card slot.
Installing the WLAN card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the WLAN card and provides a visual representation of the installation procedure.
Steps
1. Connect the antenna cables to the WLAN card.
The following table provides the antenna-cable color scheme:
Table 2. Antenna-cable color scheme
Connectors on the WLAN card Antenna-cable color
Main (white triangle) White
22 Removing and installing components
To Next Page
Loading...
