Dell Latitude 5530 - Installing the Heat Sink (for Computers Shipped with Integrated Graphics Card)

Steps
1. Remove the (M2x3) screw that secures the heat sink to the palm-rest assembly.
2. Loosen the four captive screws that secure the heat sink to the system board.
3. Lift the heat sink off the system board.
Installing the heat sink (for computers shipped with integrated
graphics card)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the installation procedure.
Steps
1. Align the screw holes on the heat sink with the screw holes on the system board.
2. Tighten the four captive screws to secure the heat sink to the system board.
3. Replace the (M2x3) screw to secure the heat sink to the palm-rest assembly.
Removing and installing components
55