Steps
Align and insert the solid-state drive holder on the system board to accommodate the M.2 2230 solid-state drive.
Next steps
1. Install the base cover.
2. Install the microSD card.
3. Install the SIM card.
4. Follow the procedure in after working inside your computer.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: You can refer the below procedure to install the M.2 2230 solid-state drive in both SLOT 1 and SLOT 2.
NOTE: SLOT1 supports only PCIe Gen4 Solid-state drive and does not support any Intel Optane.
NOTE: SLOT2 supports only PCIe Gen3 Solid-state drive and Intel Optane.
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the
installation procedure.
Figure 7. M.2 2230 solid-state drive without bracket
Removing and installing components
33
To Next Page
Loading...
