2. Lift and remove the right hinge from the display back cover.
3. Remove the (M2.5x3.5) screw that secures the left hinge to the display back cover.
4. Lift and remove the left hinge from the display back cover.
Installing the display hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display hinges and provides a visual representation of the installation
procedure.
Steps
1. Align the screw hole on the left hinge with the screw hole on the display back cover.
2. Replace the (M2.5x3.5) screw to secure the left hinge to the display back cover.
3. Align the screw hole on the right hinge with the screw hole on the display back cover.
4. Replace the (M2.5x3.5) screw to secure the right hinge to the display back cover.
Removing and installing components
91
To Next Page
Loading...
