Steps
1. Loosen the captive screw that secures the WWAN card bracket to the WWAN card.
2. Slide and remove the WWAN-card bracket off the WWAN card.
3. Disconnect the antenna cables from the WWAN card.
4. Slide at an angle and remove the WWAN card from the WWAN-card slot.
Installing the WWAN card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the WWAN card and provides a visual representation of the installation procedure.
24
Removing and installing components
To Next Page
Loading...
