1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Disconnect the battery cable from the connector on the system board.
4. Remove the WLAN card.
5. Remove the WWAN card.
6. Remove the display assembly.
7. Remove the display bezel.
8. Remove the hinge caps.
9. To remove the display panel:
a. Remove the two (M2.0 x 2.0) screws on the panel [1].
b. Lift the top edge of the display panel [2] and flip the display panel over.
c. Peel off the display connector adhesive strip from the display panel [1].
d. Peel off the Mylar tape securing the display cable on the back of the display panel [2].
e. Lift the metal tab and disconnect the display cable from the back of the display panel [3,4].
Disassembly and reassembly
35
To Next Page
Loading...
