51 Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
Caution: Renumbering stack units may hinder management scripts and monitoring software that collect
data based on particular port traffic. Use renumbering with caution when monitoring ports and be aware
that scripts and monitoring parameters may need to be modified.
In this example there are two stack members numbered 1 and 3. To change Unit 3 to Unit 2, go to
System > Stack Management > Unit Configuration and select the Switch ID to change. Enter the new
Switch ID into the
Change Switch ID to
field and click Apply.
Click OK on the next screen. Allow a few minutes for the switch to renumber, then verify the new ID from
the System > Stack Management > Stack Summary screen.
To Next Page
Loading...
