Dell Networking S3100 Series User Manual

5
Installing the Software
This information describes the initial software configuration, including connecting, booting,
configuration, and examples.
Navigating CLI Modes
The Dell Networking OS prompt changes to indicate the CLI mode.
Move linearly through the command modes, except for the end command that takes you directly to
EXEC Privilege mode, and the exit command that moves you up one command mode level.
Accessing the Console
The console port is on the I/O side of the chassis (item 1 in the following illustration).
Figure 28. Console Port Location
NOTE: You must have a password configured on a virtual terminal line before you can Telnet into
the system. Therefore, use a console connection when connecting to the system for the first time.
Before starting this procedure, be sure that you have a terminal emulation program already installed
on your PC.
40
Installing the Software

Dell Networking S3100 Series Specifications

General

Series	S3100 Series
Ports	24 or 48 x 1GbE RJ45 ports
Uplinks	2 x 10GbE SFP+ ports
Power Supply	Internal power supply
Stacking	Up to 6 units
Layer	Layer 2
MAC Address Table Size	16, 000 entries
VLANs Supported	4094
Operating Temperature	0°C to 45°C (32°F to 113°F)
Humidity	non-condensing
Jumbo Frame Support	Yes