Dell OptiPlex 5270 All-in-One - Pop-Up Camera; Removing the Pop-Up Camera

3. Install the following components:
a) System fan
b) System board shield
c) Back cover
d) Stand
4. Follow the procedure in After working inside your computer.
Pop-Up Camera
Removing the pop-up camera
1. Follow the procedure in Before working inside your computer.
2. Remove the following components:
a) Stand
b) Back cover
c) System board shield
3. To remove the camera assembly cover:
a) Remove the two screws (M3x5) that secure the camera assembly cover to the middle frame [1].
b) Lift the camera assembly cover away from the middle frame [2].
c) Disconnect the camera cable from the system board [3].
44
Removing and Installing components