Dell OptiPlex 7440 - Installing the Cable Cover; Removing the Back Cover

Installing the cable cover
1. Align the notches on the cable cover to the holes on the computer and press down, until it snaps in.
2. Tighten the screw to secure the cable cover to the computer.
3. Install the stand.
4. Follow the procedures in After Working Inside Your Computer.
Removing the back cover
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. stand
b. cable cover
3. Pry the edges of the back cover to release it from the computer.
4. Lift the back cover from the computer.
11