Option Description
System Password Allows you to set, change or delete the system password.
NOTE: Successful password changes take effect immediately.
Default setting: Not set
Internal HDD-0
Password
Allows you to set, change or delete the system’s internal hard disk’s password.
Default setting: Not set
NOTE: Successful password changes take effect immediately.
Strong Password Allows you to enforce the option to always set strong passwords.
Default Setting: Enable Strong Password is not selected.
NOTE: If Strong Password is enabled, Admin and System passwords must
contain at least one uppercase character, one lowercase character and be at
least 8 characters long.
Password
Configuration
Allows you to determine the minimum and maximum length of Administrator and
System passwords.
Password Bypass Allows you to enable or disable the permission to bypass the System and the
Internal HDD password, when they are set. The options are:
• Disabled
• Reboot bypass
Default setting: Disabled
Password Change Allows you to enable the disable permission to the System and Hard Drive
passwords when the admin password is set.
Default setting: Allow Non-Admin Password Changes is selected.
TPM 1.2 Security Allows you to enable the Trusted Platform Module (TPM) during POST. This option
is enabled by default. The options are:
• Clear
• PPI Bypass for Enabled Commands
• PPI Bypass for Disabled Commands
• Attestation Enable
• Key Storage Enable
• SHA - 256
NOTE: Activation, deactivation, and clear options are not affected if you load
the setup program's default values. Changes to this option take effect
immediately.
Computrace (R) Allows you to activate or disable the optional Computrace software The options
are:
43
To Next Page
Loading...
