Dell OptiPlex 760 - Removing the Power Button; Replacing the Power Button

Back to Contents Page
Dell™OptiPlex™760ServiceManual
Power Button
Power Button


Removing the Power Button

1. Follow the procedures in Working on Your Computer.

2. Remove the computer cover (see Removing the Computer Cover).

3. Gently squeeze the tabs securing the power button assembly to the front of the chassis, and pull the assembly away from the front of the chassis.

4. Lift the power button up until the alignment tab on the bottom of the power button assembly is free from the chassis, and remove the power button
from the chassis.

Replacing the Power Button

1. Align the tab on the bottom of the power button assembly with the corresponding slot in the front of the chassis, and push the tab into the slot.

2. Gently squeeze the tabs on the power button and push the button into the chassis until the tabs lock into place.

3. Replace the computer cover (see Replacing the Computer Cover).
Back to Contents Page

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.