Dell OptiPlex 760 - Removing the Media Card Reader


4. Attach the power and data cables to the floppy drive and to the system board.

5. Replace the computer cover (see Replacing the Computer Cover).

6. Enter system setup (see System Setup), and use the Diskette Drive option to enable your new floppy drive.

7. Verify that your computer works correctly by running the Dell Diagnostics (see Dell Diagnostics).

Media Card Reader



Removing the Media Card Reader

1. Follow the procedures in Working on Your Computer.

2. Remove the computer cover (see Removing the Computer Cover).
1
floppy drive
2
shoulder screws (4)
3
shoulder screw slots (2)


1
power cable
2
data cable
3
floppy drive connector (DSKT)


WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.