2. Unpack the replacement hard drive, and prepare it for installation.
3. If your replacement hard drive does not have the plastic hard-drive bracket attached, remove the bracket from the existing drive by unsnapping it from
the drive.
4. Attach the bracket to the new drive by snapping it onto the drive.
5. Connect the power and data cables to the drive.
6. Locate the correct slot for the drive, and slide the drive into the bay until it clicks into place.
7. Replace the floppy drive and optical drive.
CAUTION: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a foam pad, that will
sufficiently cushion it.
To Next Page
Loading...
