Dell OptiPlex 960 - Optical Drive


4. Align the shoulder screws on the media card reader with the shoulder screw slots, and gently slide it into the bay until it clicks into place.

5. Replace the drive bezel (see Replace the Drive Bezel).

6. Attach the power and data cable to the media card reader and to internal USB connector on the system board (see System Board Components).

7. Perform the procedure After Working on Your Computer).

8. Verify that your computer works correctly by running the Dell Diagnostics (see the Dell
™
Technology Guide).

Optical Drive



1
media card reader
2
shoulder screws (4)
3
shoulder screw slots (2)


1
data/power cable
2
media card reader
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before replacing the cover.