5. Install the back cover.
6. Install the stand.
7. Follow the procedure in After working inside your computer.
Display-assembly base
Removing the display-assembly base
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the graphics card.
5. Remove the system-board shield.
6. Remove the wireless card.
7. Remove the I/O cover.
8. Remove the bottom cover.
9. Remove the retractable-camera assembly.
10. Remove the fan.
11. Remove the power-supply unit.
12. Remove the power-supply fan.
13. Remove the I/O bracket.
14. Remove the speakers.
15. Remove the heat sink.
16. Remove the system board.
NOTE:
The system board can be removed with the memory, solid-state drive(s), coin-cell battery, and processor
attached.
17. Remove the audio board.
18. Remove the power-button and I/O board.
About this task
NOTE:
The display-assembly base includes the following components:
● Antenna modules
● Display panel
● Middle frame
To replace any of these components, replace the entire display-assembly base.
The following image indicates the location of the display-assembly base and provides a visual representation of the removal
procedure.
Removing and installing Field Replaceable Units (FRUs)
107
To Next Page
Loading...
