Figure 57. Removing the I/O bracket
Steps
1. Remove the two screws (M3x5) that secure the power-supply cable connector bracket to the display-assembly base.
2. Lift the power-supply cable connector bracket off the display-assembly base.
3. Remove the two screws (M3x5) that secure the I/O bracket to the display-assembly base.
4. Lift the I/O bracket off the display-assembly base.
Installing the I/O bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the I/O bracket and provides a visual representation of the installation procedure.
86
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
