Figure 75. Removing the display-assembly base
Steps
After performing the pre-requisites, you are left with the display-assembly base.
Installing the display-assembly base
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
The display-assembly base includes the following components:
● Antenna modules
● Display panel
● Middle frame
To replace any of these components, replace the entire display-assembly base.
The following image indicates the location of the display-assembly base and provides a visual representation of the installation
procedure.
108
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
