About this task
The following image indicates the location of the back cover and provides a visual representation of the installation procedure.
Figure 20. Installing the back cover
Steps
1. Align the back cover to the display-assembly base.
2. Place and slide the back cover into place on the display assembly base.
Next steps
1. Install the stand.
2. Follow the procedure in After working inside your computer.
Memory
Removing the memory
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
About this task
The following image indicates the location of the memory and provides a visual representation of the removal procedure.
44
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
