Figure 33. Moving the solid-state screw mount on M.2 slot 0
Steps
1. Remove the screw mount on the system board.
2. Install the screw mount on the system board.
Next steps
1. Install the M.2 2230 solid-state drive in slot 0 or the M.2 2280 solid-state drive in slot 0, whichever is applicable.
2. Install the system-board shield.
3. Install the back cover.
4. Install the stand.
5. Follow the procedure in After working inside your computer.
Solid-state drive in M.2 slot 1
Removing the M.2 2230 solid-state drive in M.2 slot 1
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the system-board shield.
5. Remove the I/O cover.
About this task
NOTE:
Depending on the configuration ordered, your computer may have up to two M.2 2230 or 2280 solid-state drives
installed in the solid-state drive slots on the system board.
NOTE: This procedure is applicable for computers where an M.2 2230 solid-state drive is installed in the solid-state drive
slot (M.2 PCIe SSD 1) on the system board.
The following image indicates the location of the M.2 2230 solid-state drive in M.2 slot 1 and provides a visual representation of
the removal procedure.
60
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
