5. Remove the I/O cover.
6. Remove the bottom cover.
About this task
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
Figure 59. Removing the speakers
Steps
1. Disconnect the speaker cable from its connector (INT SPKR) on the audio board.
2. Remove the speaker cable from its routing guides on the display-assembly base.
3. Lift the speakers and its cable off the display-assembly base.
Installing the speakers
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the speakers and provides a visual representation of the installation procedure.
88
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
