Steps
Insert the coin-cell battery into the socket with the positive side (+) label facing up and snap the battery in the socket.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Media-card reader
Removing the media-card reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive if applicable.
5. Remove the 3.5-inch hard drive if applicable.
6. Remove the disk-drive cage.
About this task
The following image indicates the location of the media-card reader and provides a visual representation of the removal
procedure.
Removing and installing Customer Replaceable Units (CRUs)
69
To Next Page
Loading...
