Steps
1. Remove the power-supply cables from the routing guides on the media-card reader bracket.
2. Remove the two screws (M3x5) that secure the media-card reader bracket to the system board and the chassis.
3. Disconnect the media-card reader from the connector on the system board.
4. Lift and remove the media-card reader along with the bracket from the system.
Installing the media-card reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the media-card reader and provides a visual representation of the installation
procedure.
70
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
