VGA module
Removing the VGA module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following image indicates the location of the VGA module and provides a visual representation of the removal procedure.
Steps
1. Remove the two (M2x5) cross-type screws that secure the VGA module to the chassis.
2. Disconnect the VGA-module cable from the connector on the system board.
3. Lift the VGA module off the system board.
Installing the VGA module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the VGA module and provides a visual representation of the installation procedure.
94
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
