3. Lift the serial module off the system board.
Installing the serial module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the serial module and provides a visual representation of the installation procedure.
Steps
1. Using a screwdriver, remove the serial module cover from the chassis.
NOTE: This step is applicable only when the serial module is being installed for the first time.
2. Connect the serial-module cable to the connector (KB_MS_SERIAL) on the system board
3. Insert the serial module into the slot on the chassis.
4. Replace the two (M2x5) cross type screws to secure the serial module to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
93
To Next Page
Loading...
