5. Install the side cover.
6. Follow the procedure in After working inside your computer.
Power-supply unit
Removing the power-supply unit
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive if applicable.
5. Remove the 3.5-inch hard drive if applicable.
6. Remove the disk-drive cage.
About this task
The following image indicates the location of the power-supply unit and provides a visual representation of the removal
procedure.
Removing and installing Field Replaceable Units (FRUs)
79
To Next Page
Loading...
