Steps
1. Using a screwdriver, remove the Type-C module cover from the chassis.
NOTE: This step is applicable only when the Type-C module is being installed for the first time.
2. Connect the Type-C-module cables to their connectors (VIDEO and TYPE-C) on the system board.
3. Insert the Type-C module into the slot on the chassis.
4. Replace the two (M3x3) screws that secure the Type-C module to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive if applicable.
5. Remove the 3.5-inch hard drive if applicable.
6. Remove the disk-drive cage.
7. Remove the Optional I/O modules.
8. Remove the expansion card.
Removing and installing Field Replaceable Units (FRUs)
101
To Next Page
Loading...
