7. Install the base cover.
8. Install the SD card.
9. Follow the procedure in After working inside your computer.
Display cover and antenna assembly
Replacement of the display cover and antenna assembly
CAUTION: The information in this section is intended for authorized service technicians only.
NOTE: This procedure is applicable for systems shipped with a plastic chassis only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the hinge caps.
7. Remove the display bezel.
8. Remove the hinges.
9. Remove the display panel.
10. Remove the camera module.
11. Remove the eDP cable.
NOTE:
The display cover and antenna assembly cannot be further disassembled. If the WLAN antennas are malfunctioning
and needs replacement, replace the entire display cover and antenna assembly.
About this task
The following image indicates the location of the display cover and antenna assembly and provides a visual representation of the
removal procedure.
118
Removing and installing Field Replaceable Units (FRUs)
119 / 156 118 / 154 119 / 156
To Next Page
Loading...
