Steps
After performing the pre-requisites, you are left with the display cover and antenna assembly.
Power-adapter port
Removing the power-adapter port
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Remove the display assembly.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the removal
procedure.
Removing and installing Field Replaceable Units (FRUs)
119
120 / 156 119 / 154 120 / 156
To Next Page
Loading...
