136 Installing System Components
4
Remove the cooling fan assembly. See "Removing the Cooling Fan
Assembly" on page 102.
5
If applicable, remove the cables on the power distribution board.
6
Separate the system board and the I/O board to disengage the
interconnect between the power distribution board and the I/O board:
a
Slightly lift the tab on the high-speed connector to free the release
levers. See Figure 3-30.
b
Push the release levers at an angle of 90 degrees away from the
connector to separate the system board and the power distribution
board from the I/O board. See Figure 3-30.
7
Press the release tab in the direction of the arrow and slide the board
upwards. See Figure 3-28.
8
Pull the power distribution board up until the securing slots on the board
are free from the tabs on the chassis. See Figure 3-28.
book.book Page 136 Wednesday, February 17, 2010 6:17 PM
To Next Page
Loading...
