Network Settings screen details
The Network Settings screen details are explained as follows:
About this task
Option Description
PXE Device n (n =
1 to 4)
Enables or disables the device. When enabled, a UEFI boot option is created for the device.
PXE Device n
Settings(n = 1 to
4)
Enables you to control the configuration of the PXE device.
Related References
Network Settings on page 29
Related tasks
Viewing Network Settings on page 29
System Security
You can use the System Security screen to perform specific functions such as setting the system password, setup password and
disabling the power button.
Related References
Operating with a setup password enabled on page 33
System BIOS on page 25
Related tasks
System Security Settings details on page 31
Viewing System Security on page 30
Creating a system and setup password on page 32
Using your system password to secure your system on page 33
Deleting or changing system and setup password on page 33
Viewing System Security
To view the System Security screen, perform the following steps:
Steps
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click System Security.
Related References
System Security on page 30
Related tasks
System Security Settings details on page 31
30
Pre-operating system management applications
To Next Page
Loading...
