Dell PowerEdge M630p - Page 44

Option Description
Remote Terminal
Type
Sets the remote console terminal type. This option is set to VT 100/VT 220 by default.
Redirection After
Boot
Enables or disables the BIOS console redirection when the operating system is loaded. This option is set to
Enabled by default.
Related References
Serial Communication on page 43
Related tasks
Viewing Serial Communication on page 43
System Profile Settings
You can use the System Profile Settings screen to enable specific system performance settings such as power management.
Related References
System BIOS on page 25
Related tasks
System Profile Settings details on page 44
Viewing System Profile Settings on page 44
Viewing System Profile Settings
To view the System Profile Settings screen, perform the following steps:
Steps
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click System Profile Settings.
Related References
System Profile Settings on page 44
Related tasks
System Profile Settings details on page 44
System Profile Settings details
About this task
The System Profile Settings screen details are explained as follows:
Option
Description
System Profile Sets the system profile. If you set the System Profile option to a mode other than Custom, the BIOS
automatically sets the rest of the options. You can only change the rest of the options if the mode is set to
44 Pre-operating system management applications