PowerEdge R410 Technical Guidebook
24
Dell
8.4 Processor Installation
Please refer to the PowerEdge R410 owner’s manual for information on processor installation.
(Downloadable from
www.support.dell.com)
9 Memory
9.1 Overview
• Three channels per processor
• Supports registered ECC DDR3 DIMMs or Unbuffered ECC DDDR3 DIMMs.
• DDR3 speeds of 800/1066/1333 supported
• 8 (2/1/1) DIMM sockets (64 GB Maximum capacity)
• Single rank, dual rank, and quad rank DIMMs supported
9.2 DIMMs Supported
• 1 GB, DDR3 UDIMM, 1066 with ECC
• 1 GB, DDR3 UDIMM, 1333 with ECC
• 1 GB, DDR3 RDIMM, 1066 with ECC
• 2 GB, DDR3 UDIMM, 1066 with ECC
• 2 GB, DDR3 UDIMM, 1333 with ECC
• 2 GB, DDR3 RDIMM, 1066 with ECC
• 2 GB, DDR3 RDIMM, 1333 with ECC
• 4 GB, DDR3 RDIMM, 1066 with ECC
• 4 GB, DDR3 RDIMM, 1333 with ECC
• 8 GB, DDR3 RDIMM, 1066 with ECC
9.3 Slots/Risers
The PowerEdge R410 planar provides four 72-bit (240-pin) sockets for DIMM memory modules. These
modules are DDR3-800/1066/1333 registered DDR SDRAM DIMMs. The modules are configured as
72-bits wide to provide for ECC. The memory controller in the CPU performs the ECC. The PowerEdge
R410 planar supports a minimum of 1 GB upgradable to 64 GB of RAM, using the DIMM sizes:
• 1 GB, DIMM Module
• 2 GB, DIMM Module
• 4 GB, DIMM Module
• 8 GB, DIMM Module
To Next Page
Loading...
